Thread: broken dropout . Repair or replace?
View Single Post
Old 01-26-24 | 12:27 AM
  #7  
FBinNY
Senior Member
Titanium Club Membership
15 Anniversary
 
Joined: Apr 2009
Posts: 39,897
Likes: 3,865
From: New Rochelle, NY

Bikes: too many bikes from 1967 10s (5x2)Frejus to a Sumitomo Ti/Chorus aluminum 10s (10x2), plus one non-susp mtn bike I use as my commuter

Originally Posted by Kontact
Can you TIG that close to a brazed joint? I'd take it to a good frame builder and let them do whatever process they feel is best. But I wouldn't want a visible TIG bead when they are done - fill and file it. If the frame isn't worthy of a classy repair, buy a different one. I just bought a lugged '89 KHS frameset for $50, which I would be much prouder to own than a higher end frame with an obvious repair.
Yes, you can TIG that close working fast with a good heat sink. As I mentioned, properly preparing the joint by V-notching the area so the bead is mostly sub-flush on both sides is key.
__________________
FB
Chain-L site

An ounce of diagnosis is worth a pound of cure.

Just because I'm tired of arguing, doesn't mean you're right.

“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN

WARNING, I'm from New York. Thin skinned people should maintain safe distance.
FBinNY is offline  
Reply
0