Originally Posted by
steine13
Thie following is where I really need help.
I posted this in the bike's own thread (*) but didn't get any responses. You drive-side fetishists all show your perfect bikes, but no gritty details of how the rear fender is made to fit around the chain stay bridge. I'd love to see some examples, hear descriptions, and get advice on how far -- and why -- the fender should dip below the stays. I'm inclined to just use a P clamp and attach it as shown -- but maybe I should dip lower, Dremel and all. Help.
(*)
Trek 710 with a story
To attach a fender to a brake bridge that’s not drilled, I use a plastic p-clamp:
If I need a spacer, I’ll use a section of wine correct to the appropriate length:
