Originally Posted by steelbikeguy

Great video!
That's certainly not a trivial disassembly, but it's not beyond what someone could do if they have general experience with hubs and pay close attention to what is going on.
The matter of getting the cup and cone located properly on the axle was something I wasn't thinking about either. I imagine you'd figure it out quickly, though.

Looking back... is it necessary to remove the dynamo coil from the hub shell? Aren't the cup and cone accessible w/o removing that? If you were going to be poking around the wiring, or worried about internal corrosion, then there would be a reason to look inside.

Again, excellent video! Loved the "pull start" of the hub.

Steve in Peoria