Returning to my earlier point:
Originally Posted by goldbam
I am trying to adjust the angle of the brakes with the position bolt on the top of the brake (you know the one that uses a 3 mm hex wrench). Well long story short, the bolt is completely stripped and is already as tight as it will go! So great! I cant even make it budge, and it's rubbing against my rim because I'm not able to adjust the angle.
Here you sound like you want to tighten that bolt down as much as it will go... wrong approach. You just adjust it so that the brake pads are at the right position, and then leave it as it is. Friction should keep it in place.
BTW, the basic process is: You roughly adjust the angle of the caliper with the big bolt that holds the whole caliper, and then fine tune it with the 3mm adjuster bolt.