Originally Posted by jim10040
On closer inspection, I CAN take the sensors apart! I can run a soldering iron pretty well, too. So if ANYBODY has a different suggestion, better speak up quick...the iron is (figuratively) in the fire!
The standard procedure is to wrap the wire in a neat coil fashion around the brake cable housings that is the closest in proximity to the direction of travel of the wire. This should be quite obvious. (which one)
Wrap as tight as needed to take up the extra slack.
See the instructions on page 3 of this document.
http://cateye.com/sites/cateye/uploa.../MT300v3_E.pdf