When routing your Campy cables out of the brifters is there any set rule? Right now mine are routed to the outside/inside. One cable on either side of the bar. What I notice in doing it this way is that the bar gets rather wide and fat for the hands. When I used Shimano shifters I only had one cable to worry about and it was routed to the inside of the handlebar which helped keeping the width and diameter smaller. With two cables to deal with its rather different and difficult to keep the bar width and diameter to a smaller size. Is this common with the Campy type stuff and I just have to get used to it or is it a handlebar issue? My bar is the Deda Electa and I was under the opinion that Deda modeled their bars to Campy so that's whey I went with them. Do any of you ever route the two cables to the inside and would this help with my situation.