So I recently purchased a set of older magura louise caliper/levers...they're the 2000 version that use the round pads, and are single piston.

The rear went on smoothly without a hitch. The front however is a different story...

When I installed the front caliper to my headshock and tried to install the front wheel I realized I was having clearance issues between the rotor and outer edge of the caliper.. (not the pad....the caliper body itself)...I'd try to take pics but I don't think i can actually capture it properly...

Basically it seems like the caliper needs to be about 1mm further towards the outside, but with the IS mount there is no way to do this...

As is, it won't allow free motion of my front wheel...and I don't want to try and force it and ruin my rotors by scoring them..

What should I do?