Originally Posted by Map tester
vrkelley, how are you making your turn signals blink? I bought a 2 contact turn signal relay last night at AutoZone, but when I run the power for the LED turn light through it, the light didn't blick. I don't know if I had it setup wrong or if the LED was not drawing enough power to cause the relay to activate. Anybody have any suggestions on how to make low amp LEDs blink?
MapTester,
Mine's not hooked up cuz, I couldn't figure out how to waterproof-seal the contact points. It's a basic flasher like the one pictured (except mine has battery, Pos, and Neg)
The bulbs are just the regular trailer bulbs (and no amp rating on the bulb!). I went low-tech, cuz shop owners didn't seem to know how to answer my basic questions and it was time to get going on this.