Ok, well today I went to work on it, and fooled a lot with the barrel adjusters. After a lot of adjustment to not much improvement, I went to loosen up the clamp where the cable connects to the Fd, and noticed the cable was falling out of the little clamp. I assume that this is where the problem developed in the first place. Well I fixed that, and then fooled with the tension adjustment some more, and made it even worse! Then I fooled with the limit screws, but that didn't help at all. Basically, right now the chain will only go on the smallest ring. However, even when the brifter is all the way shifted over (should be in the smallest ring), the indicator on the top of the brifter shows that it is in the middle ring. If I shift up on the brifter, the FD does not move enough to bump the chain to the middle ring, but the indicator shows the Fd as being in the big ring position. However, I can't shift it anymore although I know there must be another click of shifting. Sorry if this description is confusing to you, it is to me too. I am completely lost, and right now my plan is to take it to my LBS tomorrow and have them adjust it