Attaching Rohloff bayonet link
02-23-16, 02:50 AM
#1
Newbie
Thread Starter
Join Date: Feb 2016
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Attaching Rohloff bayonet link
Last summer I replaced the gear mech cable in my Rohloff Speedhub, and it works great except that the male bayonet links occasionally pop off the cable:
The cable is attached by inserting it in the back and then pinching it tight with those little round hex screws on the sides. But I can't seem to get enough force on the screws. Could I maybe put something on the end of the screws, where they contact the cable, to make them grip the cable better? Please let me know if anyone has a suggestion.
The cable is attached by inserting it in the back and then pinching it tight with those little round hex screws on the sides. But I can't seem to get enough force on the screws. Could I maybe put something on the end of the screws, where they contact the cable, to make them grip the cable better? Please let me know if anyone has a suggestion.
02-23-16, 10:51 AM
#2
Banned
Page 16 and 31 of the manual read?
I have the external shift Box type, Myself.
Bene Sugg: Hold the piece You show with a pair of pliers with 1 hand ,
Then tighten the set screw with the Other hand?
I have the external shift Box type, Myself.
Bene Sugg: Hold the piece You show with a pair of pliers with 1 hand ,
Then tighten the set screw with the Other hand?
Last edited by fietsbob; 02-23-16 at 10:55 AM.
