Di2 Synchro Shift problem
12-09-17 | 03:21 PM
#1
Thread Starter
Newbie
Joined: Dec 2017
Posts: 1
Likes: 0
Di2 Synchro Shift problem
Hi from the UK.
I've lurked here a while but have registered to post a question which I hope somebody can help with.
I have the required hardware for synchro shift and all firmware is up to date. I've been using it (and loving it) for several months now. I recently had to disconnect the battery as I removed the seat post, and on reconnecting I can't get synchro shift to work.
The button on junction box A still works (to set into bluetooth mode or adjust mech trim), but double clicking does not change between shifting modes. Its basically stuck in mode 1 (traditional shifting) which is working fine on both derailleurs, but I can't get it to change into modes 2 or 3.
I'd be very grateful if somebody could come up with a suggestion as to what I have done and how it can be fixed.
Cheers
Cornflake
I've lurked here a while but have registered to post a question which I hope somebody can help with.
I have the required hardware for synchro shift and all firmware is up to date. I've been using it (and loving it) for several months now. I recently had to disconnect the battery as I removed the seat post, and on reconnecting I can't get synchro shift to work.
The button on junction box A still works (to set into bluetooth mode or adjust mech trim), but double clicking does not change between shifting modes. Its basically stuck in mode 1 (traditional shifting) which is working fine on both derailleurs, but I can't get it to change into modes 2 or 3.
I'd be very grateful if somebody could come up with a suggestion as to what I have done and how it can be fixed.
Cheers
Cornflake
12-09-17 | 05:22 PM
#2
- Soli Deo Gloria -
Joined: Aug 2015
Posts: 14,779
Likes: 743
From: Northwest Georgia
Bikes: 2018 Rodriguez Custom Fixed Gear, 2017 Niner RLT 9 RDO, 2015 Bianchi Pista, 2002 Fuji Robaix
Things you can try...
Connect it to E-Tube and see if there are any faults, update firmware if needed.
Swap a known good junction from another bike.
Call Shimano. See https://www.shimano.com/en/company/locations.html for phone numbers.
Connect it to E-Tube and see if there are any faults, update firmware if needed.
Swap a known good junction from another bike.
Call Shimano. See https://www.shimano.com/en/company/locations.html for phone numbers.
Last edited by TimothyH; 12-09-17 at 05:26 PM.
