I can't inflate my front tube past 80 pounds.
03-31-24, 09:44 PM
#1
Senior Member
Thread Starter
I can't inflate my front tube past 80 pounds.
Additional strokes don't move the needle. I don't feel air coming out at the valve. A leak test in water shows no leak. Putting in a new tube doesn't help. But I have no trouble inflating my rear to 100. They both lose about 10 pounds/week.
03-31-24, 09:51 PM
#2
working on my sandal tan
Join Date: Aug 2011
Location: CID
Posts: 22,629
Bikes: 1991 Bianchi Eros, 1964 Armstrong, 1988 Diamondback Ascent, 1988 Bianchi Premio, 1987 Bianchi Sport SX, 1980s Raleigh mixte (hers), All-City Space Horse (hers)
Mentioned: 98 Post(s)
Tagged: 0 Thread(s)
Quoted: 3871 Post(s)
Liked 2,568 Times
in
1,579 Posts
Likes For Rick:
03-31-24, 11:43 PM
#5
Senior Member
your 10 psi a week is spot on with what I experience.
try changing the tube valve. sometimes they just get weird and dont work like they should.
-SP
try changing the tube valve. sometimes they just get weird and dont work like they should.
-SP
04-01-24, 07:35 AM
#6
I'm good to go!
Join Date: Jul 2017
Location: Mississippi
Posts: 15,011
Bikes: Tarmac Disc Comp Di2 - 2020
Mentioned: 51 Post(s)
Tagged: 0 Thread(s)
Quoted: 6203 Post(s)
Liked 4,817 Times
in
3,323 Posts
Using a floor pump? Are you pushing the handle all the way down on the pump? If the handle isn't going all the way to the bottom then you need to put more of your weight on it. Sometimes the check valve in the pump is sticky and needs extra pressure to open it.
Might be time to clean and rebuild the pump or if a inexpensive pump, just get another.
Might be time to clean and rebuild the pump or if a inexpensive pump, just get another.
Likes For Iride01:
04-01-24, 11:03 AM
#8
Senior Member
Join Date: Feb 2015
Location: Mission Viejo
Posts: 5,809
Bikes: 1986 Cannondale SR400 (Flat bar commuter), 1988 Cannondale Criterium XTR, 1992 Serotta T-Max, 1995 Trek 970
Mentioned: 20 Post(s)
Tagged: 0 Thread(s)
Quoted: 1944 Post(s)
Liked 2,168 Times
in
1,324 Posts
I’ve never experienced this with identical tubes and tires. The first obvious thing to try, but is a pain, is to swap tubes. The rear tire should only inflate to 80 lbs.
I’m betting that the valve is bad on the front tube. And by some coincidence the new tube valve is also restricting airflow.
Your pump might also be close to its max capacity and any restriction is too much to overcome.
If you can try a different pump with a higher rating it might inflate the tire to 100 even if there is some air restriction in the valve.
On presta valves when I have not backed the valve release nut/cap enough it is a pain to try and inflate. But another turn increasing the air flow solves it.
John
I’m betting that the valve is bad on the front tube. And by some coincidence the new tube valve is also restricting airflow.
Your pump might also be close to its max capacity and any restriction is too much to overcome.
If you can try a different pump with a higher rating it might inflate the tire to 100 even if there is some air restriction in the valve.
On presta valves when I have not backed the valve release nut/cap enough it is a pain to try and inflate. But another turn increasing the air flow solves it.
John
Last edited by 70sSanO; 04-01-24 at 11:06 AM.
04-01-24, 01:39 PM
#9
Senior Member
Join Date: Aug 2009
Posts: 2,400
Mentioned: 14 Post(s)
Tagged: 0 Thread(s)
Quoted: 1565 Post(s)
Liked 1,739 Times
in
976 Posts
It's almost for sure that the valve core is bad. The valve core has a stopper end piece which has a rubber seal ring on it. In a cheap quality core this ring would either be too loose, or become too loose. Now it expands out and becomes an o-ring, and seals all incoming air. The more pressure you pump in, the harder it seals!
Likes For icemilkcoffee:
04-02-24, 10:28 AM
#10
Expired Member
Join Date: Jun 2007
Location: TN
Posts: 11,568
Mentioned: 41 Post(s)
Tagged: 0 Thread(s)
Quoted: 3683 Post(s)
Liked 5,452 Times
in
2,771 Posts
Failure to burp the valve is the usual culprit but if that doesn't resolve it, get a different tube or swap the core.
Likes For shelbyfv:
Likes For blacknbluebikes:
04-04-24, 10:20 AM
#13
I'm good to go!
Join Date: Jul 2017
Location: Mississippi
Posts: 15,011
Bikes: Tarmac Disc Comp Di2 - 2020
Mentioned: 51 Post(s)
Tagged: 0 Thread(s)
Quoted: 6203 Post(s)
Liked 4,817 Times
in
3,323 Posts
