Shimano 3 speed maintenance
#1
Senior Member
Thread Starter
Join Date: Oct 2002
Location: Allentown, PA
Posts: 204
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Shimano 3 speed maintenance
I have just aquired a Schwinn Collegiate with a 3 speed Shimano hub. There is no oiler like the old Sturmey Archer had, do you just lay the bike on it's side and drip some motor oil into the hub ?
Also when replacing the rear wheel, do you put the trigger in #2 and adjust the bell crank to "N" to assure proper alignment?
Also when replacing the rear wheel, do you put the trigger in #2 and adjust the bell crank to "N" to assure proper alignment?
#2
Senior Member
Join Date: Jan 2002
Location: San Jose, CA
Posts: 132
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
run oil through the axle after you've removed the bell crank and the shift push rod.
You are right on the money on how to adjust the three speed.
You are right on the money on how to adjust the three speed.