Front derailer/barell adjustment compression
#1
Member
Thread Starter
Join Date: Mar 2006
Posts: 48
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Front derailer/barell adjustment compression
Replaced my front derailer cable recently, but since the change the short housing cable next to the barrel adjusted compresses as I tighten, and as such, the cable will not stay in adjustment. Today I replaced all the housing furroughs and the short section of housing but am still getting the new piece compressed.
Its gotten me stumped. Any ideas?
Its gotten me stumped. Any ideas?
#3
Member
Thread Starter
Join Date: Mar 2006
Posts: 48
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Photos are attached. The setup is like :
shifter | furrough | short section of housing | furrough | barrell adjuster | furrough | long housing to derailer
Its the short section of housing that is getting pulled thru the furroughs and compressed. The problem is that the derailer won't stay adjusted.
shifter | furrough | short section of housing | furrough | barrell adjuster | furrough | long housing to derailer
Its the short section of housing that is getting pulled thru the furroughs and compressed. The problem is that the derailer won't stay adjusted.