Stripped Cane Creek SCX-5 brake pad nut
#1
Newbie
Thread Starter
Join Date: Feb 2010
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Stripped Cane Creek SCX-5 brake pad nut
I was adjusting my SCX-5 brakes today to stop them from squealing and when tightening down one of the 5mm brake pad nuts I stripped it. I can probably get it off, but I doubt I can get it back on again so I need to get a replacement nut.
I cant seem to find replacement nuts anywhere. Are there any good sources for hardware like this? Is there a reason to not replace it with a regular nut (other than it looking odd)?
The nut in question is #1 in Fig. A: https://www.canecreek.com/manuals/Bra...structions.pdf
On a somewhat related note, where can I find a good torque wrench for all of these Allen bolts?
Thanks
Justin
I cant seem to find replacement nuts anywhere. Are there any good sources for hardware like this? Is there a reason to not replace it with a regular nut (other than it looking odd)?
The nut in question is #1 in Fig. A: https://www.canecreek.com/manuals/Bra...structions.pdf
On a somewhat related note, where can I find a good torque wrench for all of these Allen bolts?
Thanks
Justin
#2
Senior Member
Join Date: Apr 2006
Posts: 67
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
If you have a bike shop close, go ask them for one. I throw away dozens of those a week. Every time I change out the pads on a set of v-brakes. At the worst, buy a new set of pads. You'll get new nuts with those.
Thread
Thread Starter
Forum
Replies
Last Post
vol
Bicycle Mechanics
18
02-21-13 01:52 PM