Fox Float RL
#1
Newbie
Thread Starter
Join Date: Oct 2004
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Fox Float RL
Looking for some help on my Fox Float RL on a 2003 Enduro Pro.
I have been noticing a small amount of play near the reducer shaft and was wondering if I need to replace the reducer pin or bushings?
Do these wear out within a season or two?
If they need to be replaced, what special tools are required?
Any help is appreciated!
Thanks
Toronto-MTB
I have been noticing a small amount of play near the reducer shaft and was wondering if I need to replace the reducer pin or bushings?
Do these wear out within a season or two?
If they need to be replaced, what special tools are required?
Any help is appreciated!
Thanks
Toronto-MTB
#2
Senior Member
Join Date: Jan 2002
Location: San Jose, CA
Posts: 132
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
The rear bushings frequently wear out. I'm surprised it lasted this long, you may want to check the rest of the pivots on your bike, they wear too. No special tool but you may need 2 sets of Allen wrenches.
Just as a comment, you should have felt slop in the back of the bike during hard rides along with hearing an occassional clunk sound.
Just as a comment, you should have felt slop in the back of the bike during hard rides along with hearing an occassional clunk sound.