SA AW hub and GH6 Dynohub spoke confirmation
#1
Senior Member
Thread Starter
SA AW hub and GH6 Dynohub spoke confirmation
I am going to be lacing the following hubs to sun rims CR-18 590 (ERD 578mm) with new spokes, 36 hole, 3 cross. I'd measure them myself but I am a week away from seeing them.
Sturmey Archer AW hub - 274mm both sides.
Sturdmey Archer GH6 Dynohub - 267mm left, 279mm right.
I will be using one VeloFuze washer on the flange of the hub for each spoke.
Brass Spoke Washers Velofuze Spoke Head Washers Made in USA 75 Pieces | eBay
Let me know if you feel I have made an error somewhere in my planning.
Sturmey Archer AW hub - 274mm both sides.
Sturdmey Archer GH6 Dynohub - 267mm left, 279mm right.
I will be using one VeloFuze washer on the flange of the hub for each spoke.
Brass Spoke Washers Velofuze Spoke Head Washers Made in USA 75 Pieces | eBay
Let me know if you feel I have made an error somewhere in my planning.
#2
Senior Member
Join Date: Mar 2005
Location: Pinole, CA, USA
Posts: 17,392
Mentioned: 24 Post(s)
Tagged: 0 Thread(s)
Quoted: 443 Post(s)
Likes: 0
Liked 27 Times
in
25 Posts
I used two washers per spoke based on advice from someone who seemed to know what he was talking about. I can't remember who it was.
#3
Senior Member
Thread Starter
Thanks. I've gone ahead and ordered two sets of washers and the spokes above. I'll be busy building wheels for quite some time now.
#5
Senior Member
Thread Starter
Doing some reading it is an issue on big hub small (20") rim. Will it be ok 3 cross on the larger side?
Seems like it was fine for this wheel builder: https://www.bikeforums.net/bicycle-me...b-lace-up.html
Last edited by Narhay; 06-30-15 at 03:51 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ryoanji
Bicycle Mechanics
21
06-22-19 05:29 PM