Can anyone identify this frame?
#1
Can anyone identify this frame?
MTB frame with canti posts and rear cable hanger. 9 digit serial number with a gap after the first 5 digits. A lone S stamped above the sn.
Seat post pinch lugs on the front of the seat tube.
Sn# 19401 0837



Seat post pinch lugs on the front of the seat tube.
Sn# 19401 0837



#2
Hoards Thumbshifters

Joined: Jul 2010
Posts: 1,211
Likes: 429
From: Signal Mountain, TN
Bikes: '23 Black Mtn MC, '87 Bruce Gordon Chinook, '08 Jamis Aurora, '86 Trek 560, '97 Mongoose Rockadile, & '91 Trek 750
92-Mid 90's Univega mtb
Look up Alpina 5.3 to 5.7 from '94.
Look up Alpina 5.3 to 5.7 from '94.
Last edited by mechanicmatt; 03-27-22 at 11:36 AM.
#3
Thank you. Images I was able to find do support this. I should have mentioned the head tube is sized for 1 1/8"
#4
Doing some more searching, and looking closer, the Alpina 5.7 models I'm finding have some subtle differences from my frame. This example shows the top of the seat tube cut at an angle whereas mine is cut square.
The cable stops are mounted higher on the top tube on those I searched.
Also, the chain stays appear to sweep up a few inches behind the bottom bracket whereas mine are straight.
Examples below of images I found on line.

The cable stops are mounted higher on the top tube on those I searched.
Also, the chain stays appear to sweep up a few inches behind the bottom bracket whereas mine are straight.
Examples below of images I found on line.

#5
Hoards Thumbshifters

Joined: Jul 2010
Posts: 1,211
Likes: 429
From: Signal Mountain, TN
Bikes: '23 Black Mtn MC, '87 Bruce Gordon Chinook, '08 Jamis Aurora, '86 Trek 560, '97 Mongoose Rockadile, & '91 Trek 750
'95 Alpina 502? Look at different examples through the years. '97 is when v brakes start taking over so the cantilever bridge may only be on lower end models around then.






