Where can I find...
07-02-12 | 12:51 PM
#1
Thread Starter
Senior Member
Joined: Aug 2010
Posts: 1,763
Likes: 3
From: Toronto
Bikes: Pinarello Veneto, Pinarello Montello, Bianchi Celeste
Where can I find...
A good decently priced crank puller for stronglight cranks.
I believe it's 23.5 mm in size?
Damn u French bikes
I believe it's 23.5 mm in size?
Damn u French bikes
07-02-12 | 01:31 PM
#3
vintage motor
Joined: Sep 2008
Posts: 1,786
Likes: 349
From: Tepic, Nayarit, Mexico
Bikes: 48 Automoto, 49 Stallard, 50 Rotrax, 62 Jack Taylor, 67 Atala, 68 Lejeune, 72-74-75 Motobecanes, 73 RIH, 71 Zieleman, 74 Raleigh, 78 Windsor, 83 Messina (Villata), 84 Brazzo (Losa), 85 Davidson, 90 Diamondback, 92 Kestrel
There are no cheap ones.
For 35 years I used a Park CCP-1 extractor on my Stronglight 49 cranks, thinking all French cranks had the same extractor threading. I only recently found out that Stronglight and TA were different and that the Park tool was the TA size. It always worked fine, I never had the slightest problem. But CCP-1's aren't all that cheap either, so if you have to buy one anyway you might as well get the right one.
For 35 years I used a Park CCP-1 extractor on my Stronglight 49 cranks, thinking all French cranks had the same extractor threading. I only recently found out that Stronglight and TA were different and that the Park tool was the TA size. It always worked fine, I never had the slightest problem. But CCP-1's aren't all that cheap either, so if you have to buy one anyway you might as well get the right one.
Thread
Thread Starter
Forum
Replies
Last Post
songcycle
Classic & Vintage
39
08-09-17 03:34 PM
Heatherbikes
Classic & Vintage
13
02-13-12 03:48 PM
