Go Back  Bike Forums > Bike Forums > Commuting
Reload this Page >

Fender Question

Notices
Commuting Bicycle commuting is easier than you think, before you know it, you'll be hooked. Learn the tips, hints, equipment, safety requirements for safely riding your bike to work.

Fender Question

Old 11-04-11 | 11:16 AM
  #1  
snowman40's Avatar
Thread Starter
Senior Member
 
Joined: Feb 2009
Posts: 1,170
Likes: 0
From: Orange County, CA

Bikes: Fuji

Fender Question

I have a fender question.

Which ones does everybody like? Normally, I'm anti-fender just based on where I live (Orange County, California) as it doesn't rain enough to justify it. Well, that changed today as my pants seemed to have gained 5 pounds of water and my shoes changed to sponges. I'm determined to be an all weather commuter when it is safe to do so (I'll drive if there is hail, thunder and lightening, flash flood warnings etc).

I wouldn't say it was raining hard, but it was a consistent steady rain, enough for me to remove my sunglasses to see better, and add a front light so others can see me better. I'd prefer something where I can add or remove quickly as I'd only need them in the rain or threat of rain. My tires are 25s.

Many thanks in advance!

Edit - I forgot to mention, I have 2 bikes and would like to be able to move the fenders between them if I need too. So that is why I'd prefer the quick install ones.

Last edited by snowman40; 11-04-11 at 11:19 AM.
snowman40 is offline  
Reply
Old 11-04-11 | 11:25 AM
  #2  
Senior Member
 
Joined: Apr 2006
Posts: 1,840
Likes: 0
From: San Jose, CA

Bikes: Bianchi San Remo - set up as a utility bike, Peter Mooney Road bike, Peter Mooney commute bike,Dahon Folder,Schwinn Paramount Tandem

I have two bikes with fenders. One bike has the planet bike cascadia touring fenders, which are black, ugly, functional, and durable.
A second bike had the Honjo fluted aluminium fenders, which are shiney, pretty, and less ****ional than the PB fenders - the aluminium is too soft of a material to hold up long term, after about 5,000 miles, the mounting holes enlarged through vibration until the fenders were no longer practical and I swapped them out for some polished stainless steel fenders, which are not quite as pretty, but hopefully more durable.

My suggestion would be to mount the fenders on one bike, and leave them there. In OC it doesn't rain often, and you can just ride the fenderized bike when it is wet.
sauerwald is offline  
Reply
Old 11-04-11 | 11:40 AM
  #3  
Banned
 
Joined: Jun 2010
Posts: 43,586
Likes: 1,380
From: NW,Oregon Coast

Bikes: 8

Thing is the ones that are quick mount wont come down far enough
behind the front wheel.
to have a mud flap, so as to not have your feet not in the wheel spray.

once you have strut to bolt mounted mudguards on and adjusted,
they are simple to remove, and store.. no more difficult than mending a puncture.

perhaps, pick a bike of the fleet to have the mudguards stay on,
and another one for when you want the racy thing look.

Up North the opposite is true, I have to make a conscious choice ,
to take the road bike , without the fenders, out, for a sporting spin.

every other one has mudguards.
fietsbob is offline  
Reply
Old 11-04-11 | 12:16 PM
  #4  
formicaman's Avatar
Senior Member
 
Joined: Apr 2011
Posts: 332
Likes: 0
From: Philadelphia, PA
SKS fenders are super light and fairly easy to install. The longboards provide full coverage. Just make sure you get the right width for your tire - too skinny and they will rub, too fat and they will look weird. You might want to consider a pair of motorcycle boot covers like these - they fold up tiny and protect your shoes and ankles from spray. Worth noting - fenders also catch a lot of flying gravel and such, so they do serve a purpose in dry weather too.
formicaman is offline  
Reply
Old 11-04-11 | 12:21 PM
  #5  
Senior Member
 
Joined: Jul 2005
Posts: 193
Likes: 0
From: Multnomah, Portland, OR

Bikes: Cannondale six13, On-One Dirty Disco

I currently have the SKS Raceblade Fenders for my six13. They were a pain to initially configure to fit my frame/wheels perfectly, but once initial setup was complete, they work well enough for my 20 mile commute. Very light weight and you can take them on and off in seconds.
shabbis is offline  
Reply
Old 11-04-11 | 12:24 PM
  #6  
Rick@OCRR's Avatar
www.ocrebels.com
 
Joined: Aug 2006
Posts: 6,186
Likes: 8
From: Los Angeles area

Bikes: Several bikes, Road, Mountain, Commute, etc.

I use Planet Bike fenders and like them a lot. I don't remember which model, unfortunately, and I know they have several, so check out the Planet Bike website or the Planet Bike fenders at your local bike shop.

Rick / OCRR
Rick@OCRR is offline  
Reply
Old 11-04-11 | 12:31 PM
  #7  
Junior Member
 
Joined: May 2010
Posts: 8
Likes: 0
I am very pleased with the SKS Longboard fenders. The extra length really does keep you dry. Rivendell's site has an excellent installation video.
thankschub is offline  
Reply
Old 11-04-11 | 12:43 PM
  #8  
canyoneagle's Avatar
Senior Member
 
Joined: Nov 2007
Posts: 4,599
Likes: 158
From: Santa Fe, NM

Bikes: Vassago Moosknuckle Ti 29+ XTR, 90's Merckx Corsa-01 9sp Record, PROJECT: 1954 Frejus SuperCorsa

SKS P35, Planet Bike Cascadia or Axiom Rain Runner 35's are all in a similar category. Any one of those would work fine.

Once such fenders are set up properly, they can be removed and re-installed in a few minutes.
canyoneagle is offline  
Reply
Old 11-04-11 | 12:50 PM
  #9  
Puget Pounder's Avatar
Wookie Jesus inspires me.
 
Joined: Mar 2011
Posts: 2,215
Likes: 4
From: Seattle, WA
Velo orange dimpled fenders. Much classier and is a light aluminum.
Puget Pounder is offline  
Reply
Old 11-04-11 | 12:55 PM
  #10  
snowman40's Avatar
Thread Starter
Senior Member
 
Joined: Feb 2009
Posts: 1,170
Likes: 0
From: Orange County, CA

Bikes: Fuji

Ok, thank you.

I'll take a look at all of these.
snowman40 is offline  
Reply
Old 11-04-11 | 02:36 PM
  #11  
Senior Member
 
Joined: Aug 2009
Posts: 5,720
Likes: 111
From: North of Boston

Bikes: Kona Dawg, Surly 1x1, Karate Monkey, Rockhopper, Crosscheck , Burley Runabout,

Do you have room and mounting holes for fenders?
Leebo is offline  
Reply
Old 11-04-11 | 02:48 PM
  #12  
lostarchitect's Avatar
Senior Member
15 Anniversary
 
Joined: Mar 2010
Posts: 6,970
Likes: 59
From: Catskills/Brooklyn, NY

Bikes: See sig

Originally Posted by Puget Pounder
Velo orange dimpled fenders. Much classier and is a light aluminum.
Very nice, but not easy to remove.
lostarchitect is offline  
Reply
Old 11-04-11 | 03:13 PM
  #13  
snowman40's Avatar
Thread Starter
Senior Member
 
Joined: Feb 2009
Posts: 1,170
Likes: 0
From: Orange County, CA

Bikes: Fuji

Originally Posted by Leebo
Do you have room and mounting holes for fenders?
Yes, but I'm not looking for fenders that mount using the brake bolt. I have 3 kids and the less parts and tools needed, the better.

Originally Posted by lostarchitect
Very nice, but not easy to remove.
I agree, those are very nice. Not really my style as I'm looking for something.
snowman40 is offline  
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Sal Bandini
General Cycling Discussion
45
05-25-17 07:10 PM
DocsDad
Commuting
44
02-02-13 03:59 PM
bjjoondo
Tandem Cycling
46
10-16-12 11:07 AM
jakerock
Touring
43
12-08-11 08:20 PM
WalksOn2Wheels
Commuting
12
10-16-11 08:49 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.