Dropout design, frame hanger bolt hole dimension
04-27-08 | 11:29 AM
#1
Thread Starter
Senior Member
Joined: Jun 2006
Posts: 389
Likes: 0
From: Montréal, QC, Canada
Bikes: Surly 1x1 with Nexux 8 "Red line"
Dropout design, frame hanger bolt hole dimension
Hi,
I'm working on a dropout. I am working with manufacturer specs to set the size of different parts of the dropout but I'm not sure what size the hole of the fame hanger bolt should be.
The docs don't specify its size. It looks like 10mm from the drawing, but not 100% sure. what is it ?
I'm working on a dropout. I am working with manufacturer specs to set the size of different parts of the dropout but I'm not sure what size the hole of the fame hanger bolt should be.
The docs don't specify its size. It looks like 10mm from the drawing, but not 100% sure. what is it ?
04-28-08 | 07:23 AM
#2
Junior Member
Joined: Jul 2005
Posts: 10
Likes: 0
10mm, 100tpi fine pitch is typical
Remember www.sheldonbrown.com has a lot of reference numbers for sizes etc. Also, www.parktools.com has a lot of good info.
Gray
Remember www.sheldonbrown.com has a lot of reference numbers for sizes etc. Also, www.parktools.com has a lot of good info.
Gray
