Rotator no more.....?
12-24-20 | 12:10 AM
#27
Senior Member
Joined: May 2003
Posts: 4,054
Likes: 164
From: Mountain Brook. AL
Perhaps but it was clear that the Ti machine has a round tube with the axle having a through threading out the opposite
side from the mid drive cassette, where the steel machine had a square tube and according to mmatarella the axle threading
was not all the way through the square tube. So not only is the length of the axle different the Ti mount allows lock nuts on
the opposite side from the mid drive cassette where the steel tube axle bottoms out on the inside of the mount tube if I
understood mmatarella correctly.
side from the mid drive cassette, where the steel machine had a square tube and according to mmatarella the axle threading
was not all the way through the square tube. So not only is the length of the axle different the Ti mount allows lock nuts on
the opposite side from the mid drive cassette where the steel tube axle bottoms out on the inside of the mount tube if I
understood mmatarella correctly.
12-25-20 | 08:03 PM
#28
Senior Member
Joined: Dec 2004
Posts: 12,548
Likes: 797
From: Middle of da Mitten
Bikes: Trek 7500, RANS V-Rex, Optima Baron, Velokraft NoCom, M-5 Carbon Highracer, Catrike Speed
I only ever saw one Rotator, but I don't remember it being square tubing. In fact, I even found the pic.
Last edited by BlazingPedals; 12-25-20 at 08:12 PM.
