Trek FX 7.2 Clyde-Cycle
#26
Senior Member
Thread Starter
Join Date: Jun 2017
Posts: 64
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 11 Post(s)
Likes: 0
Liked 13 Times
in
9 Posts
@WOT, I did many of the same things you had done, with a Trek DS. Started with a custom quality wheelset, along with fenders and rack. Altered the saddle, stem and bars to suit, plus good lighting and safety/reflector improvements. Made a much more useful, practical and comfortable ride, at the expense of being heavier than the "floor" model as delivered. A joy to ride, by comparison.
As some have suggested, finding the right "fit" for things is a process.
The wheelset I did were: Velocity Dyad 700c 36H, DT Swiss spokes, Shimano Deore XT hubs, quality build, with Conti Tour Ride 700x1.95 tires. Not a peep through years of use on rougher urban streets and mild trails. Considered a higher spoke count, being a heavier rider, but 36H was fine given the quality of the build.
As some have suggested, finding the right "fit" for things is a process.
The wheelset I did were: Velocity Dyad 700c 36H, DT Swiss spokes, Shimano Deore XT hubs, quality build, with Conti Tour Ride 700x1.95 tires. Not a peep through years of use on rougher urban streets and mild trails. Considered a higher spoke count, being a heavier rider, but 36H was fine given the quality of the build.
The thing with the wheel build was to be certain of reliability. I expect I’ll revert to a home built 36H in due course.
#27
Senior Member
Thread Starter
Join Date: Jun 2017
Posts: 64
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 11 Post(s)
Likes: 0
Liked 13 Times
in
9 Posts
I’d been due to re-wire the rear light to tidy away the wire. Now completed and given a wipe down we’re ready for a 100km cycle in the morning to round out 1000km for September.
#29
Senior Member
Join Date: May 2014
Location: USA
Posts: 1,870
Bikes: 1996 Trek 970 ZX Single Track 2x11
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 628 Post(s)
Liked 588 Times
in
445 Posts
Very satisfied, though. Was a solid, quality build from a shop that made many thousands of wheelsets using high-quality components. On sketchy, occasionally-ratty urban streets, around my area, I've struck my share of small to medium-sized potholes. So far, not a peep from the spokes, and no other issues at all. Had I gone with a bit wider rims, fuller ties, and the same high-grade build, I suspect there would be an even greater safety margin, even without going above the 36H hubs I selected.
Thread
Thread Starter
Forum
Replies
Last Post
bikernewb
Clydesdales/Athenas (200+ lb / 91+ kg)
18
09-17-14 09:05 AM