Posted elsewhere today but... my newly christened "Portage" rack for the Pugsley.







Main tubing is 3/8 chromoly with 3/16 crosses, 3/8 tubing was bent on a 4 inch mandrel we turned out on the lathe for this purpose. The frame fittings are re-purposed zerks that we turned down in the lathe and drilled out for the 5mm bolts. The smaller oil fitting that threads into the zerk was used to make end pins / tie down points for the top and for the extra tie down, bag clips at the bottom.



Because it was designed for the Pugsley's offset frame it is plug and play and is a 3 minute task to install or remove it as there are no adjusters.