I just moved the pedals back to my bike. They don't move very often. I used a torque wrench and set them to spec.

My watch (Fenix 3) told me I'd have to set the install angles by pedaling at 80 to 90 rpm, this is normal and expected. After a moment it told me this had finished. Then it told me I had to set the install angles ... never finished this time. I cancelled it, calibrated the meter, and had watts. This has to be a watch bug, right? The PM wouldn't report power if the initial setup wasn't actually done?

Next question, what does the torque mean when you calibrate/zero the meter before you ride? It's normally in the range of about -0.1 to +0.1, today it was 5.3 - I'm seeing that on the Fenix, my Edge just says the calibration is 0.