Originally Posted by robbyville

Watched a couple of videos on installing the bar end. Other than a lot of wire fishing not too bad. Next to impossible to rip out of the bars, there is a snap retention system that is put on the end that adheres to the bar and then wrapped over with your handlebar tape. Pretty clean and nice. Other than the fact that I already have the wiring and Junction A that came with the group I may look at doing.

I got some mixed messaging on both the K-Edge Splayd computer mount and the Barfly Spoon so I've reached out to both companies. Hoping someone here will have a similar set up. Haven't found any other mounts yet.