Thread: Wiring B&M IQ-X without a rear light
View Single Post
Old 10-23-18 | 10:08 AM
  #7  
Tourist in MSN
Senior Member
15 Anniversary
Community Builder
Active Streak: 30 Days
 
Joined: Aug 2010
Posts: 12,689
Likes: 2,094
From: Madison, WI

Bikes: 1961 Ideor, 1966 Perfekt 3 Speed AB Hub, 1994 Bridgestone MB-6, 2006 Airnimal Joey, 2009 Thorn Sherpa, 2013 Thorn Nomad MkII, 2015 VO Pass Hunter, 2017 Lynskey Backroad, 2017 Raleigh Gran Prix, 1980s Bianchi Mixte on a trainer. Others are now gone.

Originally Posted by Jack.M
Oh it's that easy? Hm. I've seen people talking about "earthing"/"grounding" to the mounting bolt, etc - "isolating" just means covering and sealing?
I used electrcal tape over them. Although I planned to never install a dyno powered taillight, later I changed my mind so I was happy that I did not snip them off.

I have a different light than you, but in my case I just bundled them up under the mount out of the way. I think I used a wire twisty to hold the wires in place.

Tourist in MSN is offline  
Reply
0