Originally Posted by
Andrew R Stewart
That's pretty much what I did but my use of a SS tube was for the BB "corner". Here's the link to that short thread Grovel Bike Done - Bike Forums It has some photos showing my cable routing solutions. For this bike's replacement (which I'm close to completing the torch work) I will mimic the cable routing with tiny tweaks here and there. Andy
That seems to be the solution I'm converging on. I had one of those plastic things but it doesn't seem to fit very well so I'm using these "cable tunnel" things (ART 146 and 144) which I already have a few of left over from a previous project for all the cables.
Running some outer from the caliper under the CS looks like it fits pretty well with no extreme bends. The main thing is to make sure the cable for that rear caliper doesn't foul on the two gear cables. I might run the outer over the BB shell instead to a cable stop on the DT instead as it's a bit crowded under the shell.
Brazeons