Originally Posted by banzai_f16
Will bar-end shifters or Bar Cons fit a 22.2 mm handlebar? In particular, I'm looking at a project involving a bike I have and a trekking or butterfly bar.
I put BarCon shifters into 7/8" bars quite often. I usually have to open up the ID. I made a fixture to hold the end of the handlebar concentric to my drill press spindle and then go in about 1.25" with a 3/4" drill.
Originally Posted by banzai_f16
Also, will they allow room to "cap" off the handlebar wrap as well.
Nope. Start at the end and work towards the middle. Wrap the last inch with twine.