Originally Posted by
elayman
I cut them haha it took a while to get the blade to cut all the way through. Going to put the grips on later since I have Togo to work. So for the compressed air I have a small can that is for cleaning computers but my friend has an so compressor. Will mine work? And how do I use the air?
The can of air does not have enough volume to work. You need a compressor. Shoot the air "under" the grip to put a cushion of air between the grip and the bar. A rubber tip usually helps with this. Otherwise, most grips have a small hold on the ends. Blow air into there while pluging the other open end of the bar. The air will blow up the grip slightly and it will slide right on. Takes < 3 seconds each side to get grips on and off this way. Good luck.