Is this chain setup safe?
04-11-10 | 02:05 PM
#1
Thread Starter
Member
Joined: Oct 2009
Posts: 825
Likes: 1
From: Nor Cal
Is this chain setup safe?
Hi All,
I was removing extra links from a new Ultegra CN-6700 chain. I accidently removed too many links. I used the assembly pin included with the chain to put 2 links back into the chain. I also have a new KMC 10S master link.
Will it be ok for me to run this setup? (ie, quick link + assembly pin) I don't see a problem with it, but I figure it doesn't hurt to ask.
Thanks,
Bob
I was removing extra links from a new Ultegra CN-6700 chain. I accidently removed too many links. I used the assembly pin included with the chain to put 2 links back into the chain. I also have a new KMC 10S master link.
Will it be ok for me to run this setup? (ie, quick link + assembly pin) I don't see a problem with it, but I figure it doesn't hurt to ask.
Thanks,
Bob
