file tapering BB spindle
#26
Senior Member
Join Date: Nov 2004
Posts: 23,223
Mentioned: 654 Post(s)
Tagged: 1 Thread(s)
Quoted: 4722 Post(s)
Likes: 0
Liked 3,039 Times
in
1,877 Posts
I just happen to have a Stronglight bottom bracket with 118mm spindle and 1.37 x 24 cups. I don't suppose you have a 1st generation Dura-Ace headset?
#27
Senior Member
Join Date: Mar 2008
Location: Rhode Island (an obscure suburb of Connecticut)
Posts: 5,630
Bikes: one of each
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 8 Post(s)
Likes: 0
Liked 12 Times
in
12 Posts
W.O. Bentley.He came down out of his office one day to figure out why things were held up on the floor and it was due to the lack of the correct size nut. While the crew watched he made one by hand and by eye with a file and went back to hiss office without a word. One of the machinists checked it out later and it was perfect.
#28
Senior Member
Join Date: Aug 2011
Location: NYC+NNJ
Posts: 1,302
Bikes: i don't have a bike. a few frames, forks and some parts. that's all
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 54 Post(s)
Liked 52 Times
in
33 Posts
thanks, everyone.
pls don't worry much. not willing to file anything at all, for sure.
it was just out of curiosity in my case.
the spindle i need, at the moment, is 109 for english bb. most likely a pista size.
(sorry don't kill me here, this project is a single speed. did i say that?)
look like i will keep looking the campy family. will definitely check the bicycleclassic too.
nothing was there last time i checked.
thanks for advice, everyone!
pls don't worry much. not willing to file anything at all, for sure.
it was just out of curiosity in my case.
the spindle i need, at the moment, is 109 for english bb. most likely a pista size.
(sorry don't kill me here, this project is a single speed. did i say that?)
look like i will keep looking the campy family. will definitely check the bicycleclassic too.
nothing was there last time i checked.
thanks for advice, everyone!
Thread
Thread Starter
Forum
Replies
Last Post
AlanC8
Classic & Vintage
17
11-02-14 07:02 PM