Speed distance problem with Node 2
08-31-10 | 08:30 PM
#1
Thread Starter
Senior Member
Joined: Aug 2010
Posts: 10,304
Likes: 9,835
From: Utah
Bikes: Paletti,Pinarello Monviso,Duell Vienna,Giordana XL Super,Lemond Maillot Juane.& custom,PDG Paramount,Fuji Opus III,Davidson Impulse,Pashley Guv'nor,Evans,Fishlips,Y-Foil,Softride, Tetra Pro, CAAD8 Optimo,
Speed distance problem with Node 2
Maybe I'm just stupid but I just had a problem start up with my Node 2 computer. All had been working fine then I went out to ride one day and the speed and distance are all wrong. I went back into setup and confirmed the wheel size and that it was set to mph. Any ideas what could be causing the problem? I should note that cadence and HR are working fine. This is being used right now on my older steel bike so it's got seperate speed and cadence sensors.
09-01-10 | 06:39 PM
#2
Thread Starter
Senior Member
Joined: Aug 2010
Posts: 10,304
Likes: 9,835
From: Utah
Bikes: Paletti,Pinarello Monviso,Duell Vienna,Giordana XL Super,Lemond Maillot Juane.& custom,PDG Paramount,Fuji Opus III,Davidson Impulse,Pashley Guv'nor,Evans,Fishlips,Y-Foil,Softride, Tetra Pro, CAAD8 Optimo,
Problem solved. Yesterday I messed with the tilt of the magnet and sensor to no avail. Today I just slid the sensor less than 1/16 of an inch down the spoke and all was working fine again.
Thread
Thread Starter
Forum
Replies
Last Post
pabuck
Bicycle Mechanics
13
04-26-10 04:52 PM
