Ultegra Di2 problem
#1
Newbie
Thread Starter
Join Date: May 2014
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Ultegra Di2 problem
Hi I have just put together a TT build using second hand ultegra di2 parts except for R671 bar end shifters which are new, my RD is 6770 and FD is 6770, battery came from a 10 speed set up bmr-1, and front junction box is SM-EW67A, i didnt use SM-JC41 as ive soldered the cables internally and ive also soldered the r671 with the sm-ew67a, now my problem is the tt shifters dont seem to be cummunicating with the system, the sm-ew67a lights green when battery is connected and lights red when i hold button to put it in adjustment mode, also when i connect my road shifters 6770 to the system it works fine, my question is which component should i update the firmware? I gave the bike to my local bike mechanic and he said that the system doesnt recognise the shifters and that to disconnect right shifter but they are soldered and to avoid stripping cable again is there a solution?
any ideas?
thanks
any ideas?
thanks
#2
Senior Member
Join Date: Oct 2007
Location: West Yorkshire, United Kingdom
Posts: 5,773
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 454 Post(s)
Liked 104 Times
in
87 Posts
Why not go with the mechanics advice? Not sure why you have had to solder anything, all electronic systems should be plug & play using the manufactures cables, soldering is just going to bring in issues that they aren't designed for.
#3
Newbie
Thread Starter
Join Date: May 2014
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I will be going with the mechanics advise, I was just asking in case there is a way around it, ie update battery firmware? or FD and RD individually.. I was hoping someone had some experience with a similar problem