Headset Stack Hight Help
07-30-16 | 07:01 AM
#1
Thread Starter
Newbie
Joined: Jul 2016
Posts: 1
Likes: 0
Headset Stack Hight Help
Hi guys... Was hoping someone could help me out with a little snag Im experiencing with a winter build Im working on.
I have a frame that was designed for a tapered headset of ZS44 Top and EC49 Bottom.
My headtube length is 120mm. Now, with that information alone, one would think whats the problem.
Trouble is that I have a spacing restraint of 134mm.
What I need is a headset with a top and bottom stack that will not exceed 14mm. I figured this wouldn't be too hard to achieve with components like Zerostack or Gravity only to my surprise I can't seem to find a flush mount bottom bearing that I could use...
I never ran an EC49 lower bearing before and finding one under 5mm is like unheard-of...
Any suggestions???
Thanks
I have a frame that was designed for a tapered headset of ZS44 Top and EC49 Bottom.
My headtube length is 120mm. Now, with that information alone, one would think whats the problem.
Trouble is that I have a spacing restraint of 134mm.
What I need is a headset with a top and bottom stack that will not exceed 14mm. I figured this wouldn't be too hard to achieve with components like Zerostack or Gravity only to my surprise I can't seem to find a flush mount bottom bearing that I could use...
I never ran an EC49 lower bearing before and finding one under 5mm is like unheard-of...
Any suggestions???
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Bovabikes22
General Cycling Discussion
1
05-14-17 08:55 PM
