Go Back  Bike Forums > Bike Forums > Road Cycling
Reload this Page >

Weird effect of lowering bars by 1 inch.

Search
Notices
Road Cycling “It is by riding a bicycle that you learn the contours of a country best, since you have to sweat up the hills and coast down them. Thus you remember them as they actually are, while in a motor car only a high hill impresses you, and you have no such accurate remembrance of country you have driven through as you gain by riding a bicycle.” -- Ernest Hemingway

Weird effect of lowering bars by 1 inch.

Thread Tools
 
Search this Thread
 
Old 08-02-18 | 03:58 PM
  #26  
Senior Member
 
Joined: Oct 2009
Posts: 2,853
Likes: 261
I find that if the drops are high enough to use for a lot of the time that they are then too high for sprinting and other max efforts. It also makes the tops too high to be comfortable climbing on. So effectively I would be losing useful hand positions.
Dean V is offline  
Reply
Old 08-02-18 | 04:11 PM
  #27  
Senior Member
 
Joined: Aug 2014
Posts: 2,433
Likes: 413
Originally Posted by Dean V
I find that if the drops are high enough to use for a lot of the time that they are then too high for sprinting and other max efforts. It also makes the tops too high to be comfortable climbing on. So effectively I would be losing useful hand positions.
Thats why I like deep drop bars. It allows from the tops to be at a good height for climbing and riding in the group without having to give up a low position.
colnago62 is offline  
Reply
Old 08-02-18 | 07:00 PM
  #28  
Voodoo76's Avatar
Blast from the Past
20 Anniversary
 
Joined: Mar 2005
Posts: 3,253
Likes: 89
From: Schertz TX

Bikes: Cervelo Soloist, Felt Breed & a few more

Originally Posted by johngwheeler


I'm wondering whether the lower arm & torso position requires any adjustment to saddle height or angle?

Could the lower bars compromise power output? I feel quite sluggish, but this may just be me getting used to the new position, and I need more time to get results.

Has anyone else had the experience of feeling like you are riding a completely different bike after making a minor fit adjustment?
Saddle angle nose down a bit perhaps, but it should not impact height much unless you are making a much bigger change (like from Road to TT position). The biggest fit consequence to lowering the front end is a more acute hip angle at the top of your pedal stroke.

Everybody has a natural comfort zone for this angle. And getting too acute can cause a number of issues, among them loss of power. This may also be why the bike "feels smaller". In the TT/Tri world hip angle is a major fit variable, the adjustment is to move the seat foreword as you drop the front, opening up the hip angle. You see riders naturally doing this, riding on the nose of the saddle when they get lower.

You might try moving the seat foreword 10 to 20mm. This will likely change the seat height so you will need to reset that.
Voodoo76 is offline  
Reply
Old 08-06-18 | 08:05 PM
  #29  
Thread Starter
Senior Member
 
Joined: Mar 2017
Posts: 853
Likes: 5
From: Sydney, Australia
Quick update:

After a week riding with my lower bars, I think I've adapted and it no longer feels like I'm riding a kid's bike. The one inch drop did feel like a huge difference at first though.

Other observations:

My back and shoulders actually feel a bit better now. I'm a little bit more stretched out (8mm according to Stem Comparison Tool | yojimg.net) and my arms a little bit straighter, but still be a comfortable bend at the elbow. As with my other bike, I actually find having the bars lower stops me scrunching up my shoulders and forces me to relax my arms to lengthen them.

Getting on the drops does make the bike feel small as though I'm quite far forward over the bar. I tend to scoot back on the saddle a little to avoid the "going over the bars" feeling when braking. However, my back is quite flat, and it feels aero.

Climbing out the saddle is maybe a little weaker and less controlled than before and I need to bend my torso further forward to reach the hoods. I think I'm at the limit of bar height - any lower and I wouldn't be able to control the bike well when out of the saddle. I have longer-than-average legs for my height (34.5" inseam, 5'9.5" tall), so I guess this means my torso must be shorter-than-average - so it's harder to reach the bars unless I bend over.

As many of you have suggested, I have adapted. So far I haven't seen any noticeable speed benefit on my commute, but I'll record my rides over the next couple of months and compare data.
johngwheeler is offline  
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
johngwheeler
Road Cycling
66
12-27-20 04:30 PM
johngwheeler
Road Cycling
12
08-25-17 10:14 AM
pakossa
Fitting Your Bike
4
04-28-16 09:58 PM
Noonievut
Fitting Your Bike
9
11-02-14 04:42 AM
ambitions2o
Singlespeed & Fixed Gear
51
03-25-12 03:17 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.