Kilo TT to Felt TK-3 Sizing
#1
Hello.
Thread Starter
Join Date: Jun 2010
Posts: 200
Bikes: Windsor The Hour
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
Kilo TT to Felt TK-3 Sizing
Just came up on a good deal for a Felt TK-3.
I currently have a 55cm Kilo TT and it's a bit too big (The top tube barely clears my manhood). My inseam is around 31.5 inches. Would the 56cm Felt TK-3 be a good bet? The website says the standover is 785mm... would that work?
I currently have a 55cm Kilo TT and it's a bit too big (The top tube barely clears my manhood). My inseam is around 31.5 inches. Would the 56cm Felt TK-3 be a good bet? The website says the standover is 785mm... would that work?
#2
Senior Member
Join Date: Aug 2010
Location: St Louis
Posts: 1,846
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
With two quick searched i found that the size 55 Kilo has a stand over of 812.8mm. Now armed with that information that any reasonable person should be able to get on their own, I would assume that you could figure it out. But since you created a post about it, rather than figuring it out on your own I will lay this all out very simple for you.
The standover on the TK-3 is a little more than 1 inch lower than on your kilo. Or this much:
The standover on the TK-3 is a little more than 1 inch lower than on your kilo. Or this much:
#3
Senior Member
Join Date: Sep 2009
Location: im, hungary
Posts: 1,976
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
i saw this on cl. the guy that was selling it is a bf member. you should be fine, btw. 55 kilos fit like 57s and if its a tad big then the 56 should be fine. also, dont base standover to fit, rather tt length.