dura ace headset for my Litespeed
#1
Senior Member
Thread Starter
dura ace headset for my Litespeed
I have a Dura Ace 7410 headset on my Litespeed.Does anyone know if this is completely interchangeable with A 7400 model.There's a deal on E-Bay I may grab.Thanks!
#2
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
They are both 1" threaded headsets so if one fits your frame the other will too.
Are you asking if the bearing cartridges are interchangable so you don't have to change the cups? If so, the answer is no. Google searches on both headset models gave the following information:
The 7400 headset used 20 - 3/16" loose bearings balls in each race while the 7410 is a cartridge bearing headset so they are not at all the same.
The do have similar stack heights at 37.6 mm for the 7410 and 36.3 mm for the 7400 so your current steerer length should be fine but you will have to change the entire headset, cups, crown race and all, if you buy the 7400.
Are you asking if the bearing cartridges are interchangable so you don't have to change the cups? If so, the answer is no. Google searches on both headset models gave the following information:
The 7400 headset used 20 - 3/16" loose bearings balls in each race while the 7410 is a cartridge bearing headset so they are not at all the same.
The do have similar stack heights at 37.6 mm for the 7410 and 36.3 mm for the 7400 so your current steerer length should be fine but you will have to change the entire headset, cups, crown race and all, if you buy the 7400.
Thread
Thread Starter
Forum
Replies
Last Post
Randybb
Bicycle Mechanics
2
09-07-14 10:00 PM