Ok, I'm sick...our standard brake cable housing...
08-08-11 | 08:24 PM
#4
Thread Starter
FBoD Member at Large
Joined: Aug 2008
Posts: 6,094
Likes: 8
From: Woodbury, MN
08-08-11 | 09:42 PM
#6
Senior Member
Joined: May 2010
Posts: 5,626
Likes: 2,497
From: Bastrop Texas
Bikes: Univega, Peu P6, Peu PR-10, Ted Williams, Peu UO-8, Peu UO-18 Mixte, Peu Dolomites
Went out and measured the cables around the garage - Wow - They are all different - Mountain bike 6mm, Old campy 5mm, Swollen PVC Fuji 5.5 to 6mm, Walmart cable 6mm... Duh... The link below gives some pretty good measurements but I think its the cables that are out of line...
https://www.framebuilding.com/Braze%20ons.htm
Of course if the brake cable housing is on the side with the swollen foot it will have to be larger...
https://www.framebuilding.com/Braze%20ons.htm
Of course if the brake cable housing is on the side with the swollen foot it will have to be larger...
Last edited by zandoval; 08-08-11 at 09:51 PM.
08-08-11 | 10:25 PM
#7
Senior Member
Joined: Oct 2009
Posts: 2,470
Likes: 5
From: Minneapolis
Bikes: -1973 Motobecane Mirage -197? Velosolex L'Etoile -'71 Raleigh Super Course
Sick? As your attorney, I advise you to seek a cold beer and a hot bowl, which should deliver equanimity toot sweet.
Tandem cabling runs in 6mm housing and is surpassingly stout.
Tandem cabling runs in 6mm housing and is surpassingly stout.
Thread
Thread Starter
Forum
Replies
Last Post
elcyc
General Cycling Discussion
2
12-09-15 04:18 AM
DIMcyclist
Bicycle Mechanics
2
09-11-13 10:19 PM
