Go Back  Bike Forums > Bike Forums > Commuting
Reload this Page >

700x32 to 700x35 ride differences?

Search
Notices
Commuting Bicycle commuting is easier than you think, before you know it, you'll be hooked. Learn the tips, hints, equipment, safety requirements for safely riding your bike to work.

700x32 to 700x35 ride differences?

Thread Tools
 
Search this Thread
 
Old 04-16-18 | 11:21 PM
  #1  
suncruiser's Avatar
Thread Starter
Full Member
 
Joined: Jan 2014
Posts: 363
Likes: 14
From: Phoenix, AZ

Bikes: 2015 Trek District 8, 2017 Salsa Vaya Claris, 2012 SE Draft

700x32 to 700x35 ride differences?

I seem to have run myself into a bit of a conundrum. I bought the new schwalbe road cruiser green compound tires for my district, which is entirely used to ride on pavement and sidewalk (no place to ride on road surface on bell road unless I wish for death) and they seem to be flatting fairly frequently, as in once or more a week. I would like to move to a tire with more flat protection but schwalbe doesn't make anything in 32mm with a decent guard rating outside of the marathon plus. Thinking of moving to the marathon GT because this bike almost never sees off road but the smallest it comes in is 35mm. Would I lose much in the way of How nimble my bike feels moving up 3mm? They will still fit under my fenders, I have a good quarter inch at the lowest point.
suncruiser is offline  
Reply
Old 04-17-18 | 12:37 AM
  #2  
hermanchauw's Avatar
Senior Member
 
Joined: May 2014
Posts: 470
Likes: 15
From: Singapore

Bikes: Voodoo Hoodoo, Linus Libertine

I moved from 26x1.5 (35-559) to 26x1.25 (32-559) Panaracer T-Serv on one of my bikes. 32 is lighter and much faster to accelerate.
hermanchauw is offline  
Reply
Old 04-17-18 | 10:36 AM
  #3  
GATC
15 Anniversary
 
Joined: Jul 2006
Posts: 8,838
Likes: 182
From: south Puget Sound
I suspect the extra tire material for flat protection will affect road feel more than the move from 32 to 35mm although you will be able to run 35s at lower pressure which can compensate for some of that.
HardyWeinberg is offline  
Reply
Old 04-17-18 | 12:13 PM
  #4  
Senior Member
 
Joined: Feb 2018
Posts: 163
Likes: 2

Bikes: Two. One daily rider. One with detachment issues.

A 3mm bump on a 15 lb racing bike would be felt. A 3mm bump on a steel frame bike with fenders will be virtually undetectable. I went from 32 to 35 Marathon Supremes on my steel bike. Heck, they don't even look wider.
CreakingCrank is offline  
Reply
Old 04-17-18 | 05:51 PM
  #5  
Hoopdriver's Avatar
On Holiday
 
Joined: Apr 2017
Posts: 1,013
Likes: 15

Bikes: A bunch of old steel bikes

The difference in tire construction will affect the ride more than the difference in width. Weekly flats are insane. I don't know how you tolerate that. My suggestion is to invest in the Marathon plusses. Have them on my commuting bike and haven't flatted in over a year (3,000 + miles).
Hoopdriver is offline  
Reply
Old 04-17-18 | 06:41 PM
  #6  
suncruiser's Avatar
Thread Starter
Full Member
 
Joined: Jan 2014
Posts: 363
Likes: 14
From: Phoenix, AZ

Bikes: 2015 Trek District 8, 2017 Salsa Vaya Claris, 2012 SE Draft

Originally Posted by Hoopdriver
The difference in tire construction will affect the ride more than the difference in width. Weekly flats are insane. I don't know how you tolerate that. My suggestion is to invest in the Marathon plusses. Have them on my commuting bike and haven't flatted in over a year (3,000 + miles).
honestly considering them as well, just had good luck with the GT Tour on my vaya so far, which is the same basic construction as the GT. 1 month of riding on it, about 450 miles and no flats so far and that's cutting through a field twice a day daily
suncruiser is offline  
Reply
Old 04-17-18 | 06:57 PM
  #7  
tyrion's Avatar
Senior Member
 
Joined: Oct 2015
Posts: 4,073
Likes: 2,015
From: San Diego, California

Bikes: Velo Orange Piolet

Originally Posted by suncruiser
Would I lose much in the way of How nimble my bike feels moving up 3mm?
For nimbleness, weight might be a more important factor than size.
tyrion is offline  
Reply
Old 04-17-18 | 06:59 PM
  #8  
ThermionicScott's Avatar
Senior Member
10 Anniversary
 
Joined: Aug 2011
Posts: 22,676
Likes: 2,642
From: CID

Bikes: 1991 Bianchi Eros, 1964 Armstrong, 1988 Diamondback Ascent, 1988 Bianchi Premio, 1987 Bianchi Sport SX, 1980s Raleigh mixte (hers), All-City Space Horse (hers)

Tire construction makes a big difference. I hardly spend any time on tires smaller than 38mm these days, and I'm loving it.
ThermionicScott is offline  
Reply
Old 04-17-18 | 08:06 PM
  #9  
suncruiser's Avatar
Thread Starter
Full Member
 
Joined: Jan 2014
Posts: 363
Likes: 14
From: Phoenix, AZ

Bikes: 2015 Trek District 8, 2017 Salsa Vaya Claris, 2012 SE Draft

Originally Posted by ThermionicScott
Tire construction makes a big difference. I hardly spend any time on tires smaller than 38mm these days, and I'm loving it.
I have to admit, despite the vaya being 38lb of bike, when I put the GT Tour 38s on it really changed the entire ride. Feels faster and more nimble than when it had the stock WTB Nano 700x40 tires
suncruiser is offline  
Reply
Old 04-17-18 | 08:22 PM
  #10  
79pmooney's Avatar
Senior Member
10 Anniversary
Community Builder
 
Joined: Oct 2014
Posts: 14,153
Likes: 5,275
From: Portland, OR

Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder

Two rather general comments. 1st, a flat a week? What's causing them? If it is one thing over and over again, addressing that specific cause might work much better than just putting a tire on with enough armor to stop everything (and probably leave you with much better riding rubber).

2nd, 3mm is peanuts. Yes, you can feel it but after a mile or two, you forget IF you are comparing different sizes of the same tire. Different tires, even the same size, can be VERY different.

Ben
79pmooney is offline  
Reply
Old 04-17-18 | 09:49 PM
  #11  
suncruiser's Avatar
Thread Starter
Full Member
 
Joined: Jan 2014
Posts: 363
Likes: 14
From: Phoenix, AZ

Bikes: 2015 Trek District 8, 2017 Salsa Vaya Claris, 2012 SE Draft

Originally Posted by 79pmooney
Two rather general comments. 1st, a flat a week? What's causing them? If it is one thing over and over again, addressing that specific cause might work much better than just putting a tire on with enough armor to stop everything (and probably leave you with much better riding rubber).

2nd, 3mm is peanuts. Yes, you can feel it but after a mile or two, you forget IF you are comparing different sizes of the same tire. Different tires, even the same size, can be VERY different.

Ben
I'm voting more armor because I'm picking up goats heads all the time from I presume in the cracks in the sidewalk along bell road. Not much I can do to rectify that situation
suncruiser is offline  
Reply
Old 04-18-18 | 10:05 AM
  #12  
Banned
 
Joined: Jun 2010
Posts: 43,586
Likes: 1,380
From: NW,Oregon Coast

Bikes: 8

Casing supple ride goes up with tire cost, even if not wider, that can make a difference more than being 3mm wider.
fietsbob is offline  
Reply
Old 04-18-18 | 01:37 PM
  #13  
chas58's Avatar
Senior Member
 
Joined: Jul 2010
Posts: 4,862
Likes: 415
From: Michigan

Bikes: too many of all kinds

No, 3mm isn't something you feel. You will feel it if one tire is light and supple and one is heavier with stiffer sidewalls. Quality/construction of tire make a bigger difference than 3mm in size. I have tires sizes from 23 -60 mm in 2-3mm size increments. Even racing, 2-3mm is nothing noticeable.

I went tubless for my commuting bike - no more flats. Pinch flats are impossible and puncture flats are immediately sealed.
chas58 is offline  
Reply
Old 04-18-18 | 03:57 PM
  #14  
RubeRad's Avatar
Keepin it Wheel
10 Anniversary
Community Builder
Community Influencer
Active Streak: 30 Days
 
Joined: Aug 2011
Posts: 10,962
Likes: 5,209
From: San Diego

Bikes: Surly CrossCheck, Krampus

Originally Posted by suncruiser
I'm voting more armor because I'm picking up goats heads all the time from I presume in the cracks in the sidewalk along bell road. Not much I can do to rectify that situation
Goatheads suck, man, I feel for you.

Pick up some Stans or other tubeless MTB sealant, get tubes with removable cores, and put sealant in your tubes. A goathead can be plucked out and reseal from sealant with a couple revs. AND I've seen advice, don't even bother plucking them out. Just let them stay in there and sealant do its work. A really big obnoxious one clip it off maybe but leave the thorn in?

OR get some Mr Tuffy or other tire liners and use whatever tires you want.
RubeRad is online now  
Reply
Old 04-18-18 | 06:43 PM
  #15  
Andy_K's Avatar
Senior Member
Titanium Club Membership
15 Anniversary
 
Joined: Jan 2008
Posts: 15,097
Likes: 4,725
From: Beaverton, OR

Bikes: Yes

Originally Posted by suncruiser
I'm voting more armor because I'm picking up goats heads all the time from I presume in the cracks in the sidewalk along bell road. Not much I can do to rectify that situation
This is important information. The majority of punctures I get are from glass or bits of metal. Many nice rolling tires will resist that kind of thing. Goat heads are a different level. They are the reason that tires like the Marathon Plus exist.

You could try tubes with sealant (either pre-filled or added to tubes with removable valve cores). I don't encounter goat heads often enough to know how well that would work. If not, I think you're going to need slow and heavy tires.
__________________
My Bikes
Andy_K is offline  
Reply
Old 04-18-18 | 07:12 PM
  #16  
suncruiser's Avatar
Thread Starter
Full Member
 
Joined: Jan 2014
Posts: 363
Likes: 14
From: Phoenix, AZ

Bikes: 2015 Trek District 8, 2017 Salsa Vaya Claris, 2012 SE Draft

Originally Posted by Andy_K
This is important information. The majority of punctures I get are from glass or bits of metal. Many nice rolling tires will resist that kind of thing. Goat heads are a different level. They are the reason that tires like the Marathon Plus exist.

You could try tubes with sealant (either pre-filled or added to tubes with removable valve cores). I don't encounter goat heads often enough to know how well that would work. If not, I think you're going to need slow and heavy tires.
That's why I'm looking at the gt. With the 3mm section and the Kevlar or whatever band I think it'll hold out against the goats heads. I may end up just getting the pluses, but I have gotten goats heads in my marathon GT Tours a few times and no flats... No sealant either. The district on the other hand has 4oz of sealant in each tire and it slows the flats down but its not enough
suncruiser is offline  
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
MX_2_Spandex
Commuting
10
03-17-17 11:20 AM
mikem07
Commuting
10
02-28-16 09:19 AM
GaryPitts
General Cycling Discussion
19
03-17-12 09:14 PM
contango
Clydesdales/Athenas (200+ lb / 91+ kg)
19
07-27-11 04:13 AM
billyymc
Commuting
20
04-16-10 07:21 AM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.